Polaris 9500 Sport - Section 2. Cleaner Specifications; Section 3. Assembly; Unpacking; Assembling the Transport Caddy

Page 5
English
Section 2. Cleaner Specications
2.1 General Specications
The general specifications for the cleaner are as follows:
x 2
A
B
C
D
x 2
x 2
E
x 2
F
G
H
I
Figure 1. Transport Caddy Assembly Components
When unpacking the cleaner and its components:
• Check to make sure each component is in the box.
• Check cleaner and components for damage during
transport.
• If there are any missing parts or damage, contact
Zodiac
®
Technical Support at 1-800-822-7933.
3.2 Assembling the Transport Caddy
1. Unscrew the handnut from the base unit
(Figure 2).
Figure 2. Remove Handnut from Base Unit
2. Insert the metal handle frame tubing into the
base unit with notch end at the top, then rotate
so the bends are away from you. (Figure 3).
Control box
supply voltage
100-125 VAC, 60 Hz
Supply voltage 30 V DC
Installed load 150 W max
Cable length
9300/P93, 9400/P94: 60 ft (18 m)
9500/P95: 70ft (21m)
Cleaner size
(WxDxH)
16.9 x 18.9 x 10.6 in. ( 43 x 48 x 27 cm)
Weight of Cleaner 21 lbs. (9.5 kg)
Packed weight 42 lbs. (19 kg)
Filtration All-purpose lter canister
Cycle lengths Variable programming
The cleaner is a double-insulated product. A double-
insulated electrical appliance is one which has been
designed in such a way that it does not require a safety
connection to ground. The basic requirement for
double-insulation is that no single failure can result
in dangerous voltage becoming exposed so that it
might cause an electric shock and that this is achieved
without relying on an earthed (grounded) metal casing.
This is achieved by having two (2) layers of insulating
material surrounding live parts or by using reinforced
insulation. Therefore, devices having double-insulated
construction, such as this cleaner, do not utilize a
grounded (three-prong) cord/plug.
Section 3. Assembly
3.1 Unpacking
The packaging should contain the following items:
• Polariscleaner
• Controlunit
• RemoteControl(9500Sport/P95only)
• Transportandstoragecaddyassemblycomponents
(Figure 1)
(a) handle frame
(b) support blocks (x 2)
(c) wheels (x 2)
(d) wheel locking clips (x 2)
(e) wheel axle / hubcap (x 2)
(f) base unit
(g) cleaner hook
(h) caddy handle
(i) remote control & attachment hook