119
MAINTENANCE AND LUBRICATION
Lights
Headlight Assembly Replacement
5. Install the new headlamp by inserting the outboard pivot pin in the hole of the
mounting tab on the cab.
6. Install the adjuster bracket onto the inboard pivot pin of the headlamp.
7. Adjust for approximately 1/16” clearance between the bracket and t he edge of the
headlight. Tighten the mounting screws. IMPORTANT: Be sure the bracket is 90
degrees to the pivot pin so the lamp can move freely.
8. Install the adjusting screw, leaving it loose so the headlight can be adjusted.
9. Reinstall the front cab and connect the wire harness to the headlamp.
10. Adjust the lamps as needed, t hen tighten the adjuster screw. See page 120.
To Next Page
Loading...
Need help?
General
