REAR WHEEL REPLACEMENT
NOTE
Do not disassemble the castle nuts when you replace the rear wheel and hub
assembly.
WARNING
Improperly installed wheels can adversely affect tire wear and vehicle
handling, which can result in serious injury or death. Always ensure that all
nuts are torqued to specification. Do not service axle nuts that have a cotter pin
installed. Your authorized dealer can assist.
1. Position the vehicle on a level
surface.
2. Place the transmission in neutral.
Set the parking brake. Stop the
engine. Block the front wheel to
prevent rolling.
3. Loosen the four (4) lug nuts slightly.
4. Elevate the side of the vehicle by
placing a suitable stand under the
frame.
5. Remove the lug nuts.
6. Remove the wheel.
7. Reverse steps to install.
WHEEL NUT TORQUE SPECIFICATIONS
Check the wheel nut torques occasionally and when they've been loosened for
service.
LOCATION NUT TORQUE
All Wheels 41 Nm (30 ft-lbs)
LIGHTS
DAYTIME RUNNING LIGHTS REPLACEMENT
This vehicle’s daytime running lamps operate using LED lights. If they become
inoperable, the entire assembly will need to be replaced by your authorized
POLARIS dealer or other qualified service facility.
85
MAINTENANCE
Downloaded from ManualsNet.com search engine
To Next Page
Loading...
Need help?
General
