125
MAINTENANCE AND LUBRICATION
Lubrication
Procedure for Adding Oil
1. Remove seat and locate
dipstick (1).
2. Remove dipstick. Oil level
is shown on dipstick.
3. Add SAE 10W30 oil with a
transmission fluid funnel
until oil is at the proper level
on the dipstick. If
overfilled, excess oil will be
expelled t hrough the vent
hose.
4. Reinstall dipstick.
NOTE: Recommended Oil
Level (2).
Counter Balance Oil
Changing Procedure
1. Remove skid plate.
2. Remove counter balance
drainplug. Catchusedoil
and discard of properly.
3. Clean and reinstall drain
plug.
4. Add 10W30 oil to full mark
on dipstick. C apacity after
draining is approximately
70-75 cc (2.3 - 2.5 oz.).
5. Reinstall dipstick and check
for leaks.
1
1
2
To Next Page
Loading...
Need help?
General
