18
8.Stop and Run button: This button is used to start or stop
the hand-piece rotation, so when the system is in Hand
mode, by pressing this key, micro-motor start rotating and
by pressing again, it stops.
9.To adjust the LCD light, press Manual and Auto buttons at
the same time and you can adjust it between 0-100.
In case of hanging or locking of the panel, you can press
Auto and down arrow to reset to factory settings.
All the sent and installed panels are checked for quality and
are calibrated.
In order to start-up the device, you need at least 5 bar com-
pressor air, metropolitan gas and electricity with earth con-
nection.
To Next Page
Loading...
Need help?
General