A
B
C
D
78
MAINTENANCE AND LUBRICATIO N
Oil Change/Oil Filter Change
4. Remove both fuel injector wiring harness
connectors.
5. Place a two liter plastic bottle in the engine
compartment to catch
additional used oil, or
locate a drain pan and
a 5-foot length of
hose with a
male-to-male hose
coupler.
6. Remove the upper oil
feed hose (A) from
the top of the oil
storage reservoir.
7. Insert the hose into
the two liter bottle,
or install the coupler
into the end of the
feed hose and hang
the extended hose
over the side of the
watercraft to drain
the used oil into a
drain pan.
8. Insert the safety lanyard into the stop switch.
Press and hold the start button for no more than 15
seconds. Release the start button and wait for at
least 30 seconds. Repeat this process three or four
times or until little or no oil is pumped out of the
sump and into the container.
9. Remove the oil filter cover cap (B). Remove the
o-ring (C) and filter element (D). Replace the
filter element and o-ring with new parts.
https://www.boat-manuals.com/
To Next Page
Loading...
Need help?
General