79
MAINTENANCE AND LUBRICATIO N
Oil Change/Oil Filter Change
10. Reinstall the oil filter cover cap and torque to 17 ft.
lbs. (24 Nm).
11. Reinstall the oil supply hose to the oil storage
reservoir and torque the gear clamp to 35 in. lbs. (4
Nm).
12. Fill the oil reservoir with 3.4 qts. (3.3 l) of the
recommended oil and reinstall the oil fill cap.
Refer to the specifications section or to page 76 for
oil recommendations.
NOTE: Never add more than 4 qts. (3.7 l) to the oil
reservoir.
13. Reconnect the fuel injector wiring harness
connectors.
14. While flushing the freshwater loop cooling system,
start the engine and allow it to idle for 30 seconds.
15. Stop the engine and re-check the oil level on the
dipstick.
16. Add the recommended oil until the level is
between the MIN and MAX marks on dipstick. Do
not overfill.
NOTE: The oil level will increase slightly as the
engine warms up to operating temperature.
17. Reinstall the oil fill cap securely.
https://www.boat-manuals.com/
To Next Page
Loading...
Need help?
General