MAINTENANCE
35
Lubrication
C.
Wheel Shaft and Seal Bearing -
Apply 1-1.5 cc of grease on the
wheel shaft and seal bearing. Apply
grease evenly over the entire width
and circumference.
D. Hub - After replacing hub housing
bearings and reinstalling hub, slowly
pour 2 teaspoons (8-10 cc) of 80W90
grade oil through the hole on the top of
the hub housing. Do not overfill, pour the
recommended amount of oil.
E. Hub Bearing Seals - Apply 1.5-2 cc of
grease evenly between the hub seal’s
lips and over the entire circumference of
the seal.
IMPORTANT: Make sure the hub seal is installed
flush with the hub face. It should
not extend beyond the hub face.
F. Hub Speed Sleeve - Apply 1-1.5 cc of
grease over the entire width and
circumference of the sleeve.
G.
Frame Tubing, Tensioner Side -
Slide
the tensioner to its furthest point out.
Apply evenly a thin coat of grease,
oil or spray lubricant on the outside
of the tensioner tubing, over the
entire circumference. Always realign
the tensioner when it has been
disassembled.
NOTICE : Application of lubricant on the tensioner tubing prevents corrosion
inside the frame’s tube. Lubrication allows the tensioner to move
freely when adjusting track tension.
To Next Page
Loading...
Need help?
General
