76
4. Dust container
5. Dust container lid
WET CLEANUP CONTAINER
Fig. 4
1. Water fill lid
2. Tank
3. Wet cleanup microfiber
REMOTE CONTROL UNIT
Fig. 5
1. Main cleanup mode
2. Start/stop button, confirmation button
3. Suction power adjustment button
4. Wall-along cleanup mode
5. ON/OFF button
6. Display
7. Home button
8. Motion direction, "hours/minutes" setting buttons
9. Time setting mode selection button
10. Cleanup schedule setting mode selection button
DELIVERY SET
1. Robotic vacuum cleaner assembly - 1 pc.
2. Dust container (installed) - 1 pc.
3. Wet cleanup container with microfibre - 1 pc.
4. Battery (installed) - 1 pc.
5. Charge base - 1 pc.
6. Batteries AAA (included) – 2 pcs
7. Charger (adapter) - 1 pc.
8. Side brushes (not installed): the right brush - 2 pc.; the left brush - 2 pc.
9. Spare set of HEPA-filter - 1 pc.
10. Cleaning brush - 1 pc.
11. Spare microfibre for wet cleanup - 1 pc.
12. Remote control unit - 1 pc.
13. Operation manual - 1 pc.
14. Warranty sheet - 1 pc.
15. Package (polyethylene bag + box) - 1 pc.
APPLIANCE UNPACKING AND COMMISSIONING
Open the box, carefully extract the appliance, free it from the packaging materials.
Remove advertising sticks from the appliance body.
Check the delivery set (see "Delivery Set" Chapter).
Extract all the accessories and the charger.
Check all the accessories for damage.
Install the side brushes. For this, position the vacuum cleaner upside down. Put each of brushes on its
axle: L (white dor) is the left one, R (yellow dot) - is the right one, by slightly pushing downward until
stop.
Side brushes installation
Fig. 6
To Next Page
Loading...
