OIL AND FILTER CHANGE
Always check and change the oil at the intervals outlined in the Periodic
Maintenance Chart.
The engine drain plug
w
is located on the bottom of the crankcase. To change
the oil and filter
q
, do the following:
1. Position the vehicle on a level surface. Place the transmission in PARK.
Apply the brakes.
2. Start the engine. Allow it to idle for two to three minutes. Stop the engine.
3. Clean the area around the drain plug.
CAUTION
The sealing surfaces on drain plug and crankcase should be clean and free of
burrs, nicks or scratches.
4. Place a drain pan beneath engine crankcase and remove the drain plug.
5. Allow the oil to drain completely.
6. Reinstall the sealing washer on the drain plug.
TIP
The sealing surfaces on drain plug and crankcase should be clean and free of
burrs, nicks or scratches.
89
MAINTENANCE
Downloaded from ManualsNet.com search engine
To Next Page
Loading...
