32
FEATURES AND CONTROLS
Instrument Cluster
High water pressure may damage components. Wash the vehicle by hand or with a garden
hose using mild soap. Do not use alcohol to clean the instrument cluster. Do not allow insect
sprays to contact the lens.
Speedometer
The speedometer displays vehicle speed in either miles per hour (MPH) or kilometers per
hour (km/h). See page 34.
Indicator Lamps
Lamp Indicates Condition
Vehicle Speed
When standard mode is selected, speed displays in miles per hour.
When metric mode is selected, speed displays in kilometers per hour.
Over Temperature This lamp illuminates to indicate an overheated engine. If the
indicator flashes, the overheating condition remains, and the system
will automatically reduce engine power.
EPS Warning This indicator illuminates briefly when the key is turned to the ON
position. If the light remains on, the EPS system is inoperative. Your
authorized POLARIS dealer can assist.
Brake Failure This lamp illuminates when low pressure is detected in the hydraulic
brake system (if equipped).
High Beam This lamp illuminates when the headlamp switch is set to high beam.
Helmet/Seat Belt This lamp is a reminder to the operator to ensure all riders are
wearing helmets and seat belts before operating. The driver’s seat
belt is equipped with a seat belt interlock. Vehicle speed will be limited
to 24 km/h (15 MPH) if the seat belt is not secured.
Check Engine This indicator appears if an EFI-related fault occurs. Do not operate
the vehicle if this warning appears. Serious engine damage could
result. See your dealer.
Direction Indicators A direction indicator flashes when a turn signal is active. Both
indicators flash when the hazard signal is active.
Rider Information
Center
Speedometer Indicator
Lamps
MODE
Button
To Next Page
Loading...
Need help?
General
