8.26
9850043 R01 - 2017-2021 RANGER 500 / 570 Service Manual
© Copyright Polaris Inc.
12.Thoroughly clean all parts. Inspect the bearing
surfaces of the output hub. Inspect the rollers
a
for
nicks, scratches and flat spots. Inspect the roll cage
o
for damage or cracks. The rollers must slide up
and down freely within the roller cage surfaces.
13.Inspect the ring gear
i
for inconsistent wear patterns
or damage. The surfaces should be free of nicks or
burrs.
14.Inspect roll cage (B) sliding surface. This surface
must be clean and free of nicks, burrs or scratches.
Inspect the H-springs, but do not remove them
from the roll cage.
15.Inspect the armature plate for a consistent wear
pattern. Uneven wear of the armature plate indicates
a warped plate, which may cause intermittent
operation.
NOTICE
See “FRONT GEARCASE DIAGNOSIS” later in this
chapter for more details.
16.Drill a hole in the input shaft seal
d
and remove the
seal using a pry bar or seal puller.
FINAL DRIVE
To Next Page
Loading...
Need help?
General
