Vehicles subjected to severe use must be serviced at 50% of the stated interval.
Examples of Severe Use: Frequent immersion in mud, water, or sand, constant
high RPM use, prolonged low-speed heavy load operation, extended idle, and
short trip cold weather operation.
INITIAL BREAK-IN SERVICE
FIRST 25 HOURS / 250 MILES (400 KM)
Brake System
Initial fluid level inspection; inspect for fluid
leaks; add lubricant if needed. Inspect brake
pad wear.
Engine Oil and Filter Change the engine oil and filter.
Front Gearcase Fluid
Initial fluid level inspection; inspect for fluid
leaks; add lubricant if needed.
Transmission Fluid
Initial fluid level inspection; inspect for fluid
leaks; add lubricant if needed.
The break-in period consists of the first 25 hours of operation. Careful
treatment of a new engine and drive components will result in more efficient
performance and longer life for these components. The items outlined in this
service interval only need to be performed at the first 25 hours of operation.
They do not need to be performed every 25 hours.
Vehicles subjected to severe use must be serviced at 50% of the stated interval.
Examples of Severe Use: Frequent immersion in mud, water, or sand, constant
high RPM use, prolonged low-speed heavy load operation, extended idle, and
short trip cold weather operation.
EVERY 50 HOURS / 500 MILES (800 KM)
Brake Pad Wear
Inspect; replace as needed.
General Lubrication
Locate all applicable fittings and grease.
Engine Breather Inspect; clean as needed
84
MAINTENANCE
To Next Page
Loading...
Need help?
General
