8. Using a cap-style oil filter wrench or equivalent, turn the filter
e
counter-
clockwise to remove it.
9. Using a clean dry cloth, clean the filter sealing surface on the crankcase.
Make sure the old filter o-ring is completely removed.
10.Lubricate the o-ring on the new filter with a film of fresh engine oil. Check to
make sure the o- ring is in good condition.
11. Install the new filter and turn by hand until the filter gasket contacts the
sealing surface, then turn an additional 3/4 turn.
12.Always clean away all dirt and debris from the dipstick area before removing
the dipstick. Remove the oil cap
r
or the dipstick
t
and fill the sump with
1.9 liters (2 qts.) of recommended oil.
13.Reinstall and tighten the dipstick.
108
MAINTENANCE
To Next Page
Loading...
