FLUID CHANGE
The drain plug is located on the bottom of the gearcase. Access the drain plug
through the hole in the skid plate.
1. Remove the fill plug.
2. Place a drain pan under the drain plug
w
.
3. Remove the drain plug. Allow the fluid to drain completely.
4. Clean and reinstall the drain plug. Torque to specification.
5. Add the recommended fluid to the bottom of the fill plug hole. Do not overfill.
6. Reinstall the fill plug. Torque to specification.
7. Check for leaks. Discard used fluid properly.
FRONT GEARCASE (DEMAND DRIVE)
Always check and change the front gearcase oil at the intervals outlined in the
POLARIS Maintenance Schedule beginning on page 99. Maintain the oil level
even with the bottom thread of the fill plug hole.
Refer to the Gearcase Specifications Chart for recommended lubricants,
capacities and torque specifications. See page 159 for the part numbers of
POLARIS products.
112
MAINTENANCE
To Next Page
Loading...
Need help?
General
