12.If winching at an angle is unavoidable, follow these precautions:
a. Look at the winch drum occasionally. Never let the winch cable “stack” or
accumulate at one end of the winch drum. Too much winch cable at one
end of the winch drum can damage the winch and the winch cable.
b. If stacking occurs, stop winching. Follow step 15 of Winch Operation to
feed and rewind the cable evenly before continuing the winch operation.
13.Never winch up or down at sharp angles. This can destabilize the winching
vehicle and possibly cause it to move without warning.
14.Never attempt to winch loads that weigh more than the winch’s rated
capacity.
15.The winch motor may become hot during winch use. If you winch for more
than 45 seconds, or if the winch stalls during operation, stop winching and
permit the winch to cool down for 10 minutes before using it again.
16.Never touch, push, pull or straddle the winch cable while winching a load.
17.Never let the winch cable run through your hands, even if wearing heavy
gloves.
18.Never release the clutch on the winch when the winch cable is under load.
19.Never use the winch for lifting or transporting people.
20.Never use the winch to hoist or suspend a vertical load.
21.Always inspect your winch and winch cable before each use.
86
WINCH GUIDE
To Next Page
Loading...
Need help?
General
