MANUAL PLOW MODE
Manual Plow Mode allows you to use the Ride Command touchscreen display to
raise and lower the plow.
To raise and lower the
plow, do the following:
1. To raise the plow, press
the up arrow on the
touchscreen display
and slide it to the left.
2. To lower the plow,
press the down arrow
on the touchscreen
display and slide it to
the left.
AUTO PLOW MODE
Automatic Mode allows the display to automatically lower the plow when you
shift to Low and will automatically raise the plow when you shift to Reverse.
To switch to AUTO plow
mode, the system requires
the following conditions to
be met:
1. Plow must be fully up
and the autostop
fairlead must be
detecting the rubber
stopper.
2. Gear Position must be
in Park
3. The Winch in and
Winch out relays must
be in place in the
fusebox (factory
installed)
NOTE
Auto-plow mode will be disabled if excessive speed is detected.
36
FEATURES AND CONTROLS
To Next Page
Loading...
Need help?
General
