PLOW MODE (IF EQUIPPED)
NOTE
Plow Mode is a feature available for use with RANGER XP 1000 vehicles that
have a factory installed Ride Command System with a winch and auto stop
winch fairlead as part of the factory wiring harness.
NOTE
It is not recommended to use plow mode with winch in rapid recovery mode.
Plow Mode is an
automated plow control
system based on vehicle
gear position. To enable
Plow Mode, do the
following:
1. On the display, go to
“Settings,” “Vehicle,”
and then select “Plow
Installed.”
2. From the Plow installed
screen, move the
toggle switch from “No”
to “Yes.”
NOTE
The procedure above is only required one time. The system will remember
your settings for future use. If you want to disable seeing the plow mode
screen as part of the gauges screen option, you can set the toggle back to “No”
at a later date.
35
FEATURES AND CONTROLS
To Next Page
Loading...
Need help?
General
