Polaris RZR XP 1000 2022 User Manual

4. Remove all debris from the entire clutch air duct passage
w
.
5. Check for signs of damage to seals on the transmission and engine. If any
seals appear to be damaged, your vehicle requires prompt service. Your
POLARIS dealer or other qualified person can assist.
TIP
Belt slip is responsible for creating excessive heat that destroys belts, wears
clutch components and causes outer clutch covers to fail. Switch to low range
while operating at slower speeds to extend the life of the PVT components
(belt, cover, etc.)
PVT DRYING
There may be some instances when water is accidently ingested into the PVT
system. Use the following instructions to dry it out before operating.
NOTICE
When washing the vehicle, always avoid spraying water directly toward the
PVT intake duct. See the Washing the Vehicle section for details.
1. Remove the clutch cover drain plug.
2. Allow the water to drain. Reinstall the drain plug.
3. Place the transmission in PARK. Apply the brakes.
4. Start the engine.
5. Apply varying throttle for 10-15 seconds to expel the moisture and air-dry the
belt and clutches. Do not hold the throttle wide open for more than 10
seconds.
6. Allow the engine RPM to settle to idle speed. Apply the brakes. Shift the
transmission to the lowest available range.
150
MAINTENANCE

Polaris RZR XP 1000 2022 Specifications

General

Brand	Polaris
Model	RZR XP 1000 2022
Category	Offroad Vehicle
Language	English