46
OPERATION
Using Cruise Control
The cruise control switches are located on the turn signal lever. Make sure you read this
section and understand how to safely operate this feature before using the cruise control.
WARNING! Improper operation of cruise control could cause loss of control and result in serious injury
or death. Follow all cruise operation procedures carefully. Never use cruise control when roads are wet
or slippery. Do not use cruise control when driving in heavy or congested traffic.
Cruise Control Tips
• Cruise control can be set in any gear.
• Vehicle speed must be above 25 MPH (40 km/h).
• Set speed will vary slightly in hilly terrain.
• The cruise control will not resume a pre-set speed if the resulting acceleration or deceleration rate is
too high or too low. For example, resuming a set speed from 30 MPH (48 km/h) while in 5th gear
may cause cruise to disengage.
• Cruise control will not engage if brake lights are not operating properly.
• Cruise control will be disabled if there is an active stability or traction control event.
• Cruise control will be disabled if there are multiple wheel speed sensor faults or a communication
error with the electronic stability module.
Set Speed
1. Move the cruise control ON/OFF/
RES switch to ON to activate the
cruise control.
2. Accelerate to the desired speed.
Press and release the SET switch at
the tip of the lever.
Cancel Cruise Control
To temporarily cancel the cruise control
and allow use of the resume feature,
perform one of the following:
• depress the brake pedal or
• depress the clutch pedal
To cancel the cruise control and erase
the set speed from memory, move the
ON/OFF/RES switch to OFF.
Cruise Control
ON/OFF/RES
Switch
RES (+)
ON
OFF
S
E
T
(
-
)
To Next Page
Loading...
Need help?
General
