Polaris Slingshot SL 2015 - Safety During Service Procedures

47
OPERATION
Using Cruise Control
Resume Speed
1. Disengage the cruise control by depressing the brake pedal or clutch pedal.
NOTE: If you depress the throttle pedal to accelerate, the cruise control will resume the previously set
speed when the pedal is released.
2. Move the ON/OFF/RES switch to RES to resume operation at the previously set speed.
NOTE: Moving the ON/OFF/RES switch to OFF will erase the set speed from memory and disengage
the cruise control.
Increase Speed Setting
Move and release the ON/OFF/RES switch to RES to increase the set speed in
approximately one MPH (1-2 km/h) increments. Move and hold the ON/OFF/RES switch in
the RES position to accelerate to a new SET speed. The speed will reset when the switch is
released or after a maximum acceleration of approximately 10 MPH (16 km/h), whichever
comes first.
Reduce Speed Setting
Press and release the SET switch to decrease speed in approximately one MPH (1-2 km/h)
increments. Press and hold the SET switch to decelerate to a new SET speed (resets when
switch is released), or to the minimum cruise speed of 25 MPH (40 km/h).