MAINTENANCE
2.7
LUBRICATION
* More often under severe use, such as operated in water or under severe loads.
¡ Semi-annually or 50 hours of operation (refer to Maintenance Schedule for additional information)
More often under severe conditions (operating in water or hauling heavy loads)
© Annually or 100 hours of operation (refer to Maintenance Schedule for additional information)
More often under severe conditions (operating in water or hauling heavy loads)
¢ Grease conforming to NLGI No. 2, such as Polaris Premium All Season Grease, Conoco Superlube M or
Mobilegrease Special
Ill.
#
Item Lube Rec. Method Frequency*
1. Engine Oil Polaris 0W--40
Synthetic
Check dipstick and add to
proper level.
Change after 1st month, 6 months or 100
hours thereafter; Change more often
(25-50 hours) in extremely dirty condi-
tions, or short trip cold weather operation.
2. Transmis-
sion
Polaris AGL Gear-
case Lubricant
Add lube to bottom of fill hole. Change annually ©
3. Front Gear
Case
Premium Demand
Drive Hub Fluid
Drain completely. Add lube to spe-
cified quantity.
Change annually ©
4. Rear Gear
Case
ATV Angle Drive
Fluid
Drain completely. Add lube to spe-
cified quantity.
Change annually ©
5. Brake Fluid Polaris Dot 3 Brake
Fluid
Fill master cylinder reservoir to in-
dicated level inside reservoir.
As required. Change fluid every 2 years
2. Transmission
1. Engine Oil and Filter
5. Brake Fluid (Left hand Master Cylinder)
Fill / Check
Plug
3. Front Gear Case Fill Plug
Fill Plug
Fill plug
4. Rear Gear Case Fill Plug
Master Cylinder
Reservoir
Dipstick
Fill / Check
Drain Plug
Late 2004
Early 2004
Drain Plug
To Next Page
Loading...
