85
MAINTENANCE
Engine Oil
Oil and Filter Change
10. Place shop towels beneath the oil
filter. Using an oil filter wrench
(available from your POLARIS
dealer), turn the filter counter-
clockwise to remove it.
11. Using a clean dry cloth, clean the
filter sealing surface on the
crankcase.
12. Lubricate the o-ring on the new
filter with a film of fresh engine
oil. Check to make sure the o-ring
is in good condition.
13. Install the new filter and rotate it
clockwise by hand until the filter
gasket contacts the sealing
surface, then turn it an additional
1/2 turn.
14. Remove the dipstick. Add the proper amount of the recommended
oil. Do not overfill.
15. Reinstall the dipstick.
16. XP 1000 only: Reinstall the guard plate over the oil filter access.
17. Place the transmission in PARK.
18. Lock the parking brake.
19. Start the engine. Allow it to idle for one to two minutes.
20. Stop the engine.
21. Check for leaks.
22. Check the oil level. Add oil as needed to bring the level to the upper
mark on the dipstick.
23. Dispose of used filter and oil properly.
Oil Filter
To Next Page
Loading...
