54
FEATURES AND CONTRO LS
Instrument Cluster
Rider Information Center
Diagnostic Mode
Screen 5: Programmable service interval
The programmable service interval provides a convenient reminder
when routine maintenance is due. This feature is pre-set at 50 hours.
You must enable t he programmable service interval before it can be
used.
When set, the hours of operation are subtract ed from the set hours until
0 is reached. The wrench icon will flash quickly for five seconds each
time the engine is started as a reminder that service is due.
Setting the Service Interval
1. Press and hold t he mode/overri de button until the wrench icon
flashes. Release the button.
2. Press the button once to advance the setting by one hour. Press and
hold the button to advance the hours at a faster pace.
3. When the desired time increment is displayed, release the button.
When the wrench stops flashing, service hours are set.
NOTE: If you scroll past the intended number , hold the button down
until the count turns over to 0. You can then reset the
number.
Disabling the Service Interval
1. Toggle t o the service i nterval mode.
2. Press and hold the mode button for approximately seven (7)
seconds. The service interval is disabled when the word OFF
displays.
Screen 6: Miles/Kilometers toggle
The display in the tripmeter and odometer can be changed to display
either kilometers or miles. The current display mode will be shown as
either KM or MP.
1. Press and hold the mode button until the l etters flash.
2. Press and release t he mode button once. When the display stops
flashing, the mode has been set.
To Next Page
Loading...
