100
SPECIAL PROCEDURES
MFI Operation
SECURITY LOCK: Briefly pressing and releasing the LOCK button
will cause the lock status to be displayed,either “LOCKED” or
“UNLOCKED”. Pressing and holding the LOCK button for several
seconds initiates the SECURITY LOCK function. The MFI will
display“ENTERCODE____”.Enterthecodeusingthe5-button
keypad. The factory set default code is “1234”. An asterisk (*) will
appear with each press of a numeric button. If the proper code has been
entered, the display will show the new lock status. If previously
“LOCKED”, the security lock will switch to “UNLOCKED” and the
vehicle may be started normally. If previously “UNLOCKED”, the
security lock will switch to “LOCKED” and the vehicle will not start.
If starting the engine is attempted while the security lock is set to
“LOCKED”, t he warning LED will flash, the engine will not start, and
the MFI will indicate “LOCKED”, followed by “ENTER CODE_ _ _
_”. If an improper code entered, the MFI will display “INVALID
CODE”, and exit code entry mode.
CODE SET MODE: The factory set default security code is “1234”,
however, the code may be changed t o any 4 digit number. To select
your own code, enter CODE SET mode by pressing and continuing to
hold the LOCK button for several seconds until “CHANGE CODE” is
displayed (the display will first show the lock status, followed by
“ENTERCODE____”,andfinally“CHANGE CODE”. The MFI
willthendisplay“OLDCODE____”.Enterthecodeasiflockingor
unlocking the vehicle. If the correct code is entered, the display will
thenshow“NEWCODE____”.Selectany4-digitcode.Thedisplay
willthenread“CONFIRMCODE____”.Enterthesamecodeto
confirm your selection. “CODE CONFIRMED” will display for
several seconds if the second entry of the new code matches the first. If
the second code entered does not match the first, “INVALID CODE”
will be displayed and the CODE SET MODE is cancelled.
DISPLAY: Pressing the DISPLAY button toggles the MFI between
NORMAL DISPLAY mode and DIGITAL DISPLAY mode. The lower
display will show VOLTS/DISTANCE/HOURS when in NORMAL
mode, and real-time digital RPM and SPEED when in DIGITAL mode.
When first entering DIGITAL DISPLAY mode, the MFI briefly
displays the last recorded peak RPM and SPEED. While the peak
values are being displayed, holding the DISPLAY button for several
seconds will reset the peak values. Pressing the DISPLAY button while
in DIGITAL DISPLAY mode toggles the display back to the standard
VOLT/DISTANCE/HOURS display.
To Next Page
Loading...
Need help?
General
