11
2.5 I Star ng the cleaning cycle
To prevent all risks of injury or equipment damage, comply with the following direc ves:
• Bathing is prohibited when the appliance is in the pool.
• Do not use the appliance during shock chlorina on.
• Do not leave the appliance una ended for an extended period.
• Do not use the appliance if the roller shu er is closed.
• When the control box is powered up, the following symbols light up to indicate:
- The ac on in progress
- The cleaning cycle selected (depending on the model)
- that maintenance is required
• The control box switches to standby a er 10 minutes and the screen is switched o . Press any key to exit standby
mode. Standby mode does not stop the appliance if it is in a cleaning cycle.
2.5.1 Selec ng the cleaning cycle (depending on the model)
• A cleaning cycle is already con gured by default: the symbols are lit.
• The cleaning cycle can be selected at any me, before the appliance starts or while it is opera ng. The new cycle will
start immediately.
• The cleaner adapts its movement strategy depending on the choice in order to op mise coverage.
Surface to be cleaned
Floor only
Floor + walls + waterline
2.5.2 Launching the cleaning cycle
• Press
Tip to improve cleaning performance
At the start of the bathing season, launch several cleaning cycles in oor only mode (a er removing the large
debris with a net).
Regular use of the cleaner (without exceeding 3 cycles per week) means that your pool will always be clean
and the lter less clogged.
2.5.3 Adjus ng the cleaning me (depending on model)
• You may reduce or increase the cleaning me at any me (+/- 0.5 H).
• Press the bu on:
Durée
normale
- 0.5 H
+ 0.5 H
Normal
dura on
To Next Page
Loading...
Need help?
General
