Electrical Systems
7.45
Starter Motor -- Assembly
1. 2 Rubber Ring*
2. 4 Brush Spring
3. 1 Thrust Washer
4. 1 Gear Assembly
5. 1 O-Ring*
6. 1 Brush Complete
7. 1 O-Ring*
8. AR Thrust Washer
9. 1 Shaft Complete
10. 1 Gear Assembly
11. 1 Through Bolt
12. 1 Cover
13. 1 Stopper
14. 1 Snap Ring
15. 2 Washer
16. 2 Flange Bolt
*Do not reuse. Replace with new parts.
Starter Assembly
1. Install brush plate to field magnet housing
aligning index tab.
2. Install O-ring, two small phenolic spacers, large
phenolic washer, flat washer , lock washer, and
terminal nut.
3. While holding brush springs away from brushes,
push brushes back and hold in place.
4. Slide armature into field magnet housing.
Release brushes.
5. Lightly grease drive end bushing and reinstall
drive end frame on armature. Inspect seal for
wear or damage. Replace drive end cap if
necessary.
1*
1*
3
2
4
5*
6
16
11
7*
8
15
9
10
12
13
14
15
Re Qt Description
To Next Page
Loading...