Electrical Systems
7.46
Starter Motor -- Assembly -- Continued
6. Be sure wire insulation is in place around
positive brush wire and pushed completely into
slot on phenolic plate.
7. Using a non-petroleum grease, lubricate brush
end bushing and install shims.
8. Align brush plate and install cover and screws.
9. Reinstall bolts and tighten evenly and securely.
10. Lightly grease pinion shaft and install pinion,
spring stopper , and snap ring.
Starter Solenoid Bench Test
To measure the resistance of the pull-in coil, connect
one meter lead to the Yellow/Red wire and the other
to ground. The resistance should be 2.8-3.6 ohms.
Refer to Electric Starter System Testing in this
section to further test the solenoid.
Nyogelt Grease PN 2871329
To Next Page
Loading...