Attaching the Wrist Strap and
Inserting the Batteries
Page 1
To attach the wrist strap, Insert the wrist strap
through the ring on the side of the camera (1).
Push the opposite end of the strap through the
loop and pull (2).
To
insert the batteries, open the battery compartment
on the bottom of the camera. Insert two AA-batteries
(alkaline only) into the compartment as shown. Make
sure the ends of the batteries are positioned accord-
ing to the markings (+) and (-) inside the compart-
ment cover.
Loading the Film
1. To open the film compartment, push the latch in
the direction of the arrow (1) and lift open the
door (2).
2. Insert a film cartridge into the chamber. Place the
flat end of the cartridge over the white post in the
chamber.
3. Pull the film leader until it reaches the film tip
indicator (▲ FILM TIP). The best method is to hold the
cartridge down with the right hand while pulling the film
with the left.
Close the film compartment door until it clicks.
4. Press the shutter button three (3x) or four (4x)
times until the number 1 appears in the status
window.
To Next Page
Loading...
Need help?
General
