e. Press the S10/S1 buttons through their entire travel. They should move smoothly
with no binding.
f. With the front door open, look into the film compartment. Check the following:
- Pack spring and battery contacts are not distorted.
- Taking mirror is not broken, loose or scratched.
- Spread roll bracket assembly components are OK and rollers move freely.
- Spread rollers are clean.
- With pick height gauge #12430 or #12504 (see P.A. SX-70 #291) see that the pick
is positioned correctly.
- No foreign material in film cavity.
- Hanger is in proper position.
- Pack pawl leg is in a down position and not distorted.
- Cone filler #550851A is in position or cone has molded fix (See RIB 600AM #6).
3. Functional Test
Perform the following functional test on the 636 camera using film pack simulator #12467
(.3 ohms) and power supply Power Mate #12531 or Lambda #12429.
1. Setup
a. Plug the film pack simulator into the power supply. Be sure the polarity is correct.
b. Plug the power supply into a 110 VAC source.
c. Turn the power supply switch ON.
d. Adjust the output voltage to 6.0 volts.
76
To Next Page
Loading...
Need help?
General
