EN-8EN-7
2.4 Powering the Device On / Off
2.4.1 Auto Power On / Off
Once the vehicle engine is started, the device automatically turns on and
recording (must have SD Card). After the car engine stopped, the device will
automatically save the last recorded le and shutdown.
2.4.2 Manual Power On / Off and Reset
2.4.2.1 Manual Power On / off
1. Connect one end of power connector to USB port on the device.
2. Plug the other end of the power adaptor to the cigarette lighter socket of
your vehicle. Once the vehicle engine is started, the device automatically
turns on.
Press Power button to turn it on.
To power off the device press the
Power button with 3 seconds.
2.5 Set the Date / Time
To set the correct date and time, press Menu button to enter the menu
setting, then press Up / Down button to select 2015/01/19 17:56 ,
press OK button to enter date / time setting, then press Up / Down button
to adjust the value, press Mode button switch to next setting, after
nished all the settings, press OK button to back menu option, press
Menu button to exit from menu setting.
2.4.2.2 Reset the Device
2.6 Mode Selection
The default setting is Video Mode , press Mode button can switch to
Videos View Mode .
3 Using the Driving Recorder
3.1 Recording Videos
Before starting recording, please insert a SD card (not included) into the SD
card slot. Press OK button to start recording, the video recording icon
ashes on the screen. The recorded les are saved on the SD card. To stop
recording, press OK button again.
In case the device fails to function
normally due to unknown causes, press
the button, then press the button
to restart the device.
With car power adaptor connected the device will automatically turn on and
start recording when the car engine starts. When the engine stops, the device
will automatically save the last le and turn off.
Polaroid·DS301 Polaroid·DS301
To Next Page
Loading...
Need help?
General
