12
2) Attach stickers to the connection between the head and the data cable: use
scissors to cut the stickers according to the red line identification, and use the cut stickers to
protect the lower and upper parts of the slot of the flat line of the head to prevent the
splashed ink from entering the slot, causing the nozzle to be short circuited and burned, as
shown in Figure 2 and Figure 3 below.
3) Put the installed nozzle into the designated position in the trolley, use M3 * 8 socket head
cap screws to pass through the ink bag fastener, and fix the nozzle on the trolley bottom
plate.
4) Install the ink cartridges: Install the ink cartridges of the four ink colors of No.1 nozzle from left
to right in the order of "KCMY" as follows.
5) Connect the other end of the nozzle data line to the nozzle plate, as shown in the figure
below.
To Next Page
Loading...
