Polaroid FIRST - Page 11

11
5. 1orizontal gear ratio calibration: X motor interface, gear ratio setting, calibration behind the point.
After the automatic calibration of the machine is completed, click the save option under the file
in the upper left corner to save.
4.3 head installation
1. Parts required for installing the head
No.
Name
Quantity
Unit
note
1
i3200 damper
8
pcs
2
Head data cable（14p/55cm）
8
pcs
3
Head sticker
4
pcs
4
M3*8 Socket head cap screw
6
pcs
5
M2.5 L key
1
pcs
Accessory bag
6
i3200 head
2
pcs
Self provided
7
Cross screwdriver
1
pcs
Self provided
8
scissors
1
pcs
Self provided
Remarks: The materials required for installing the head are all in the carriage sealing pocket, except
for the head. Common tools are provided by the user.
2. Installation steps of head
1) Installation of the flat line of the head: insert the 14P flat line into the head according to the
mark, pay attention to the mark of the flat line, and insert it on the upper and lower
interfaces of the nozzle accordingly to prevent the flat line from being inserted reversely, as
shown in Figure 1 below.