10
4.2 Precautions before installation of head
1. Check the machine: Check the appearance and accessories of the machine to see if they are
complete. Remove the fixed sheet metal parts of the carriage and see if the carriage can be
pushed from left to right normally without abnormal noise.
2. Software installation: install the printing software on the computer and set the local network IP, as
shown in the following figure:
3. Online: connect the power supply to the machine, connect the network cable, open the
machine control software on the computer, and turn on the machine. Observe the reset action
of the machine. The specific reset action of the trolley on the platform is as follows: Start up and
wait for about 10 seconds → the cleaning mechanism descends → the carriage moves about
15cm to the left → the carriage moves to the right and returns to the original point → the carriage
moves to the left again (rebound distance) → the cleaning mechanism rises → the software is
online.
4. Enter the factory engineer mode: in the box behind Software Advanced and Factory Settings,
enter 222222, press Ctrl+F12, and click OK to enter.
To Next Page
Loading...
