11
FUNCTION INTRODUCTION
MENU OPERATION
1. Use the On Screen Display menu to set and adjust functions
2. Use CH+/CH- to select the desired menu after pressing MENU, then press Vol+/OK to enter
the next submenu; Use Vol+/Vol- to select the menu options and return to the previous menu
by pressing MENU again. The menu will disappear without any operation within 10 seconds.
In TV, AV, S-VIDEO, YPbPr and PC modes
Picture
● Brightness
To adjust the picture’s brightness
●
Contrast
To adjust the picture’s contrast
●
Sharpness
To adjust the picture’s definition
● Colour
To adjust the picture’s color
●
Tint
To adjust the picture’s tint. (For NTSC signal only)
Note: Picture menu options in other signal sources:
AV, S-VIDEO: the same as in TV mode
YPbPr, PC: Brightness and Contrast only
Sound
● Volume
To increase or decrease the volume
●
Balance
To balance the volume between the left and right speakers
● Woofer
To turn on/off the woofer
● Spatial
To turn on/off the surround sound
● Equalizer (submenu)
Use OK/Vol+ to enter the Equalizer submenu, you
can increase or decrease the value of the sound
output in different frequency ranges
Note: The Sound menu options are the same in TV
signal mode as well as in other signal source modes
To Next Page
Loading...
Need help?
General