Impulse Series Camera User Guide
9
Troubleshooting
Possible picture problems and their solutions
Problem Cause Solution
Repeated spots The developer rollers inside Open the film door (do not do this
or bar pattern the film door need to be in direct sunlight, when there is film
cleaned. in the camera).
Clean the developer rollers with a
lint-free cloth dampened with
water, if necessary.
Background to dark The background was either too Be sure the lighten/darken
far from the subject or beyond control is in center position.
the flash range.
Place your subject near the
background and keep both within
the applicable flash range.
Impulse - 4 to 10 feet (1.2 to 3m)
Impulse AF - 2 to 14 feet (.6 to
4.25m)
Unsharp picture The subject was too close to Be sure your subject is at least
the camera. 4 feet (1.2m) from the camera.
To Next Page
Loading...
Need help?
General
