My PDC 2030 Camera
LCD displays ”
” and
a continuous beep sound
will be heard.
This means there is
insufcient battery power.
You need to replace the batteries.
Symptom
Problem Solution
My CD installation wizard
does not work.
The auto installation le is
switched to off.
or
The CD ROM is
disconnected.
Go to the computer desktop
Right click on “My Computer”.
Click “Properties”. Select “Device
Manager”. Double click on “CD-
Rom”, double click on “CD-R”
(Normally the manufacturer’s
name). Click on “ Setting . Ensure
“Auto insert notication “ is ticked
and the “ disconnect “ is ticked.
If you change the settings the
computer will ask you to restart
your PC. Click “ Yes “
or
You can manually start by going to
the Windows Desktop, double click
“My Computer”, double click your
CD ROM icon and nally double
click “INSTALL-E.EXE” le.
My PDC 2030 Camera
hanged and all buttons do
not work.
Take out all the batteries and
disconnect the camera from the
computer for 10 seconds. Re-insert
the batteries again.
Your camera may be
affected by the electrostatic
discharge.
Flash pictures are too
dark.
Take picture in well lit room or move
closer to subject.
Insuffcent light or too far
from subject.
AVI le cannot be played. DirectX version is lower
than 8.0.
install directx 8.0 or above.Visit
http://www.microsoft.com/directx
for more detail.
When connect the camera
to the PC in Capture
mode, Windows prompt
to insert system disk.
PDC 2030 driver installation
has not completed.
Insert the Windows CD or PDC 2030
driver CD. If PDC 2030 driver CD is
inserted, please set the path to “CD-
Rom drive\software\Driver\Sysle”.
And continue the installation.
Please also refer to the help files & User Guides that accompany the
enclosed applications.
For further information and support, please visit our
website: http://www.polaroid-digital.com
To Next Page
Loading...
