Polaroid Play+ 3DPen User Manual

5
OPERATING INSTRUCTIONS
Start Button
Filament
Loading Point
USB Cable
Entry Point
Nozzle
Power Button
Speed Control
Button
LED Indicator
Light
LED Speed
Indicator Lights
Filament is inserted
into the pen here.
A 5.0 Volt DC,
2 Amp power adapter
(5.0VDC 2.0A)
MUST be used.
The lament
will extrude
from here.
DO NOT
TOUCH!
When ready
to use, the
nozzle will
be hot.
Red light indicates
the pen is heating
up.
Blue light indicates
the pen is ready to
use.
Press the ‘Power Button’ to turn
the pen on and o󰀨.
Hold the power button for 2
seconds to automatically retract
the lament from the pen.
These will show the speed
at which the lament will
extrude from the pen:
1 light shows the
speed is set to ‘Fine’
and the lament will
extrude slowly from
the pen.
2 lights show the
speed is set to
‘Normal’ and the
lament will extrude
steadily from the pen.
3 lights shows the
speed is set to ‘Rapid’
and the lament will
extrude quickly from
the pen.
3 speed settings:
Rapid, Normal, Fine.
Manual Extrusion:
press and hold to extrude
lament from the nozzle,
and release to stop.
Auto Extrusion:
click once to start extruding
lament from the nozzle,
and click again to stop.

Polaroid Play+ 3DPen Specifications

General

Brand	Polaroid
Model	Play+ 3DPen
Category	Accessories
Language	English