18
12. Start moving the device using a very slow linear motions along the jaw line.
13. To ensure optimal results, use the device for 5 minutes on each side.
After the entire treatment area has been treated, the treatment session is
complete. As a natural result of the treatment, the skin may show some
redness (erythema) and minor skin swelling (edema) in the treatment
area. Both should disappear after a short time.
14. Press the Power button for two seconds to turn the device OFF.
15. Unplug the power supply from the electrical outlet.
16. Gently remove the TriPollar
®
Preparation Gel from your skin and wash
your face. You can apply a moisturizer if desired.
17. Clean the electrodes of the device with a damp cloth or paper towel and
cover the device tip with its protective cover.
Warning: Do not submerge the TriPollar
®
Stop VX device under
water.
Safety Mechanism:
The device’s automatic temperature-optimization mechanism protects the
skin from overheating. When the skin has reached the maximal temperature, the
energy source will shut down automatically. The indication is - green LED off.
The device automatically turns the energy source back ON, when the skin
temperature drops below the maximal temperature or when you move the
device to an adjacent treatment area, where the skin temperature is lower.
The indication is - green LED on.
Important:
The orange light is ON when the skin temperature in the treatment area is
sufficiently heated and is OFF when it is not.
To Next Page
Loading...
