13
The indication lights on the TriPollar
®
Stop VX device works as follows:
GREEN LIGHTS INDICATE RF MODE
• A single green light means that the device is ON and is operating in low-
level RF mode.
• Two green lights mean that the device is operating in high-level RF mode.
BLUE LIGHTS INDICATE RF + DMA MODE
• A single blue light means that the device is operating in low-level RF
and DMA mode.
• Two blue lights mean that the device is operating in high-level RF
and DMA mode.
BEFORE YOU BEGIN
Before using the TriPollar
®
Stop VX device, do the following.
1.
Open the box containing the device, and remove the device and its
power supply.
2. Insert the adapter onto the electrical posts (FIG.9)
3.
Mount the adapter on the PS until it securely "clicks into place". Connect
the power supply to the device (FIG.10)
4. Connect the power supply to the device (FIG.11)
To Next Page
Loading...
