17
8. Once the orange indicator light illuminates followed by a 'beep' sound, you
have reached the optimal temperature. Continue the same slow circular
motion for a few moments and then gradually enlarge your movements
in the treatment area.
Proceed with this technique covering the entire treatment area, making
sure the orange indicator light is illuminated as much as possible during
the treatment.
As you move from one treatment area to another (FIG.16), the orange
indicator light may turn-off if the temperature of the skin is not warm
enough.
9. Continue working on the entire treatment area in a slow circular motion for
4-5 minutes. Make sure to maintain a uniform heating while covering the
entire treatment area. Treatment can be augmented by “lifting” movements
from the jaw line upwards toward your cheeks.
10. Once you finished the 4-5 minutes of treatment, you can proceed to the
next treatment area repeating steps 6-9.
11. Switch to RF + DMA mode. It's recommended to start at the Low power
level.
Important: Use the RF + DMA mode ONLY on the jaw line area
(FIG.18). Do not use on other facial areas.
TREATMENT
AREAS
FIG.17 FIG.18FIG.16
To Next Page
Loading...
