13
BEFORE YOU BEGIN
Before using the TriPollar
®
Stop X device, do the following.
1.
Open the box containing the device, and remove the device and its
power supply.
2. Insert the adapter onto the electrical posts (Fig.9)
3.
Push the adapter into the slot of the PS until it securely "clicks into place"
and cannot be removed easily (Fig.10)
4. Connect the power supply to the device (Fig.11)
5. Plug the power supply into an electrical outlet (Fig.12)
6. Remove the TriPollar
®
Preparation Gel from its box.
Important: Before using the device for the first time, it is recommended
to perform a patch test 24 hours prior to initial use. To do so, apply a
small amount of TriPollar
®
Preparation Gel to the inner arm and treat
the area with the TriPollar
®
Stop X device. Ensure that the skin does not
have a negative reaction to the gel or treatment.
7. Remove the protective cover from the device.
You are now ready to treat your skin using TriPollar
®
Stop X,
as described on page 15.
To Next Page
Loading...
