15
TREATING YOUR SKIN
To treat your skin using the TriPollar
®
Stop X device:
1. Cleanse and dry the treatment area.
2.
Apply a very thin, even layer of TriPollar
®
Preparation Gel over the entire
treatment area (face and/or neck). This gel must be used during the
entire treatment session. Your skin may feel a warm sensation when
the gel is applied.
3.
Turn the device ON by pressing the Power button (Fig.13). Make sure that
the green indicator light turns ON.
Tip: A long press of the Power button turns the device OFF.
4. Select the power setting (Low/High) that is most comfortable for you. When
the green indicator light shows a single green light illuminated (Fig.14), the
device is operating at the Low power level. You can press the Power button
again to change to the High power level (Fig.15).
To Next Page
Loading...
