7.1 CLEANING THE DUST COLLECTOR TANK
- Empty the dust-collector tank as described
in Section 6.
- Detach the tank from the main body by
pressing the detach button (10)(11).
- Rotate the top cover of the tank
anticlockwise and extract it (13). Rotate
clockwise to lock it again (14) (align the
symbols).
- Remove the tank filter and sponge (15).
Remove any remaining dirt.
- Rinse all the components under running
water and let them dry.
- Replace everything by performing these
steps in reverse order.
The EPA filter should be fully cleaned
approximately every four months.
Filters are sold at Polti authorized service
centres and at
www.polti.co.uk
7.2 CLEANING THE BRUSH
To clean the brush, proceed as follows:
- Move the locking cursor outwards (16).
- Remove the bristly cylinder (17).
- Clean the bristle cylinder.
- Replace everything by performing these
steps in reverse order.
8. STORAGE
8.1 Ensure that the appliance is switched off
and not charging.
8.2 Empty the dust collector tank when it
reaches the maximum level.
WARNING: Check that all dust collector
components are dry before reassembling
them.
WARNING: Check the condition of filters
during cleaning. Replace filters when visibly
damaged.
Rinse the tank filter using running water
only and shake gently to remove any excess
dirt or water residue. Before replacing the
filter in the appliance, leave to dry naturally,
away from sources of heat, for at least 24
hours.
WARNING: Do not clean the filter with the
brush, as it can be damaged, thereby
reducing the filtering capacity. Do not use
detergents, do not rub the filter, and do not
wash it in a dishwasher.
ENGLISH
| 24 |
To Next Page
Loading...
