To Next PageTo Next PageWhy does my POLTI Steam Cleaner have no suction?
If the POLTI Steam Cleaner exhibits no or reduced suction, ensure the dirt collector isn't full and is correctly inserted. Adjust suction using the cursor on the handle. Also, verify the dirt collector tank and flexible vacuum tube are correctly inserted. Clean the filters as described in chapter 18 and the tubes as described in Chapter 22.
Why does my POLTI Steam Cleaner motor have little suction?
If the motor of your POLTI Steam Cleaner revs or has little suction, there may be blockages in the tubes or accessories. Turn off the appliance, unplug it, and remove any obstructions in the tubes and accessories.
How to clean POLTI Steam Cleaner Multibrush?
If you notice lines or traces of dirt remaining after cleaning with your POLTI Steam Cleaner, the Multibrush may be dirty. Clean the Multibrush by washing it under running water and allow it to dry completely before using it again.
How to fix POLTI Steam Cleaner that won't turn on?
If your POLTI Steam Cleaner does not turn on, the issue might be with the power supply. Check the cable, plug, and socket to ensure they are functioning correctly.
What to do if POLTI Steam Cleaner leaks water?
If water collects under the POLTI Steam Cleaner during liquid vacuuming, it's likely that the liquid in the dirt collector has exceeded the maximum level or there is foam present. Empty the dirt collector and follow the cleaning instructions in Chapters 17, 18, and 22.
Why is my POLTI Steam Cleaner not dispensing steam?
If the POLTI Steam Cleaner does not dispense steam, first ensure the boiler is switched on. If it is, check that the boiler has enough water. Make sure the steam hose is correctly inserted and the steam lock on the handle is deactivated. Finally, wait for the steam indicator light to stop flashing, indicating the boiler is pressurized.
What to do if POLTI Steam Cleaner releases little steam?
If your POLTI Steam Cleaner is pressurized but releases little steam, the steam level might be set too low. Press the steam adjustment button (+) to increase the amount of steam being dispensed.
Why does POLTI Steam Cleaner dispense water with steam?
If steam is dispensed mixed with drops of water from your POLTI Steam Cleaner, the steam hose and/or the telescopic tube may be cold. Direct the steam jet onto a cloth to heat up the tubes.
Why doesn't the universal brush selector on my POLTI Steam Cleaner work?
If the universal brush selector on your POLTI Steam Cleaner does not work, check if the holder with cloth for steam cleaning is mounted on the brush. If it is, remove the holder with cloth from the brush.
How to lock cloth holder on POLTI Steam Cleaner brush?
If the holder with cloth for steam cleaning does not lock onto the brush of your POLTI Steam Cleaner, ensure the universal brush is set to position A.
General| Power | 2200 W |
|---|---|
| Water Tank Capacity | 1.2 L |
| Weight | 8.5 kg |
| Cord Length | 8 m |
| Tank capacity | 1.2 L |
| Filters | HEPA filter |
| Surface Recommendation | Hard floors, Carpets |
| Functions | Vacuuming, Steam Cleaning |
