To Next PageTo Next PageWhy are POLTI Steam Cleaner accessories hard to assemble?
If accessories are difficult to assemble on your POLTI Steam Cleaner, the seals may be producing friction. Lubricate the gasket with silicone grease, Vaseline, or a small amount of vegetable oil.
What to do if POLTI Steam Cleaner doesn't dry in preset mode?
If, in preset-program mode, there was no time to finish drying with your POLTI Steam Cleaner, it may be due to vacuuming too slowly over the surfaces. In preset-program mode, you can still activate suction by pressing the suction button.
Why is my POLTI Steam Cleaner leaking steam from the handle?
If steam or condensation leaks out between the handle and the telescopic tube of your POLTI Steam Cleaner, the seals may be worn, cut, or missing. Replace the seals as indicated in Chapter 24.
Why does POLTI Steam Cleaner leave water on the floor?
If, after vacuuming with your POLTI Steam Cleaner, traces of liquid remain on the flooring, liquid may remain inside the tubes, or the floor may not yet be dry. Suck in air for a few seconds to allow the transfer of the liquid to the tank. Repeat the vacuuming.
General| Power | 2200 W |
|---|---|
| Water Tank Capacity | 1.2 L |
| Weight | 8.5 kg |
| Cord Length | 8 m |
| Tank capacity | 1.2 L |
| Filters | HEPA filter |
| Surface Recommendation | Hard floors, Carpets |
| Functions | Vacuuming, Steam Cleaning |
