To Next PageTo Next PageWhat to do if my POLTI Steam Cleaner does not dispense steam?
If your POLTI Steam Cleaner isn't dispensing steam, it could be due to several reasons: the water tank might be empty (add water as described in Chapter 11), the steam lock on the handle might be activated (deactivate it), the boiler might not be fully pressurized (wait for the steam indicator light), or the steam hose might be trapped or twisted (check and correct the hose).
Why are my floors too wet after using POLTI Steam Cleaner?
If your floors are too wet after using the POLTI Steam Cleaner, it might be due to the initial burst of steam or inactivity (direct the steam jet onto a rag for a few seconds), the steam level being too high (reduce the quantity of steam), or the room temperature being too cold (reduce steam and dispense intermittently).
General| Type | Steam Mop |
|---|---|
| Power | 1500 W |
| Water Tank Capacity | 0.5 L |
| Heating Time | 30 seconds |
| Cord Length | 6 m |
| Steam output | 90 g/min |
| Surface Recommendation | Carpets, Hard floors |
| Accessories | Carpet attachment |
