restart itself. The packages need to all be on the USB drive and not in a zip. The current packages are
frontend, modules, ingen and extra-content. If you’ve updated recently and know that one le hasn’t
changed then you don’t need to include it on the USB ash drive next update and it’ll update a little
faster.
The USB ash drive must be formatted FAT32 and have one partition on it. If the update fails, please try
pressing export presets in the settings screen. If that also fails then the USB ash drive is unreadable,
either due to having no partitions (partitonless drive) or being the wrong format. Please contact me
for help. Please use a normal USB ash drive and not an external hard drive. The cheap NXT ones
from Staples work well. All Sandisk ones tested also worked well. Verbatim ones tested have failed.
1.12. INPUTS AS EFFECTS LOOPS
You can use the input / outputs of Digit as effect loops. For example, physically connect output 3 to an
external phaser pedal, then connect the output of the phaser to input 3. Then on Digit, connect a delay
to output 3, and then connect input 3 directly to output 1. The repeats of that delay will now be running
through the phaser. Be careful not to create feedback paths, or route dry in parallel where some signal
goes through external pedals. The extra latency / phase difference between the direct and effected
signals can cause weird effects. So it’s always safer just to effect things like delays / reverb tails.
1.13. RHYTHMIC DELAYS
Tap a delay to see the details.
There are two modes. If you choose beats you can set a BPM and then choose a subdivision in the
right drop down menu.
12
To Next Page
Loading...
Need help?
General
