33
Administration
HANDSET ADMINISTRATION
FAQs
How does the handset power off and power on?
The
END key is the power on/power off key. Press and hold it to turn the
handset on. Turn the handset off from the standby mode by pressing and
holding the
END key. If you are in an active call, end the call by pressing
the
END key. This returns the handset to the standby mode, then press
END again to turn the handset off.
How do I place a call and terminate a call?
To place a call, press the
START key and then dial the number. End the
call by pressing the
END key. You can also use the speakerphone instead
of the
START key.
Can I change the ring?
The ring is fully adjustable and may be set differently for different pro-
files. For a complete explanation of how to change the ring, see the
Changing Ring Settings section of this guide.
How do I change the voice volume and the ringing volume?
Whether using a headset, the speakerphone, or the internal speaker,
the speaker volume for the current call may be raised or lowered by
pressing the up and down volume buttons on the side of the handset.
The volume buttons may be pressed while the handset is ringing to
raise or lower the ring volume, which also changes the ring volume set-
ting in the current profile.
To Next Page
Loading...
Need help?
General
