4. Insert the Pins down through the top of the T-Fittings until the Pins snap into place on the lower
side of the T-Fitting.
5. Carefully slide the Vertical Legs up through
the liner’s belt that runs around the middle of
the pool, and then lock each one into the hold
of the T-Fitting.
6. Continue working around the perimeter
until the entire liner is securely connected to
the frame.
7. To make sure the poles are perpendicular to
the ground (and not leaning), pull out the
vertical legs. This will make the walls straighter.
Funsicle Customer Service
Website: funsicle.com/support
Phone: 888-670-4FUN (888-670-4386)
Email: HelloFun@Funsicle.com
STEP THREE: Add 1 inch of water to the pool and then install filtration system.
3. Continue adding water to your pool and refer to the “Funsicle Activity Pool User Guide” for
information and best practices for using, maintaining, draining, storing and/or winterizing
your pool.
2. Install the filtration system as per the enclosed “Funsicle Skimmerplus Filter Pump User Guide.”
1. After ensuring that the drain fitting is plugged securely and the cap is in place, fill the pool
with about an inch of water. Then stop filling, and smooth out all wrinkles in the liner.
To Previous Page
Loading...
Need help?
General
